How to Apply Your 3-Layer Glitter Tattoo Stencil
How to Remove the Clear Top Sheet
Your stencil has 3 layers:
Clear Transfer Sheet — TOP
Stencil — MIDDLE
Backing Paper — BOTTOM
Step 1 — Apply to Clean, Dry Skin
Use an alcohol pad to remove any oils or dirt from the area. Place the stencil sticky-side down onto the skin. Press firmly over the entire design, especially around small details and edges.
Step 2 — Remove the Clear Sheet
Starting at one corner, slowly peel the clear sheet back over itself, keeping it close and parallel to the skin rather than pulling straight upward.
Important: The stencil should remain on the skin while only the clear sheet comes away.
Step 4 — If the Stencil Starts to Lift
Stop peeling. Lay the clear sheet back down and press/rub the stencil firmly onto the skin,
then continue removing the clear sheet slowly.
Step 5 — Ready for Glitter!
Once the clear transfer sheet has been completely removed, your stencil is ready for cosmetic adhesive and glitter.
PRO TIP:Peel low + peel slow. Pulling the clear sheet straight up can lift small pieces of the stencil.
Comments